adapter_gpio_config Struct Reference

Configuration options for a single GPIO. More...

Data Fields
bool	active_low
unsigned int	chip_num
enum adapter_gpio_drive_mode	drive
enum adapter_gpio_exit_state	exit_state
unsigned int	gpio_num
enum adapter_gpio_init_state	init_state
enum adapter_gpio_pull	pull

Detailed Description

Configuration options for a single GPIO.

Definition at line 68 of file adapter.h.

Field Documentation

active_low

bool adapter_gpio_config::active_low

Definition at line 74 of file adapter.h.

Referenced by bcm2835_swdio_read(), bcm2835gpio_swd_write_fast(), COMMAND_HELPER(), get_gpio_mode(), get_gpio_value(), set_gpio_value(), and set_pin_state().

chip_num

unsigned int adapter_gpio_config::chip_num

Definition at line 70 of file adapter.h.

Referenced by am335xgpio_reset(), COMMAND_HELPER(), get_gpio_value(), initialize_gpio(), and is_gpio_config_valid().

drive

enum adapter_gpio_drive_mode adapter_gpio_config::drive

Definition at line 70 of file adapter.h.

Referenced by COMMAND_HELPER(), get_gpio_mode(), initialize_gpio(), and set_gpio_value().

exit_state

enum adapter_gpio_exit_state adapter_gpio_config::exit_state

Definition at line 70 of file adapter.h.

Referenced by COMMAND_HELPER(), and parport_quit().

gpio_num

unsigned int adapter_gpio_config::gpio_num

Definition at line 69 of file adapter.h.

Referenced by am335xgpio_reset(), bcm2835_swdio_read(), bcm2835gpio_read(), bcm2835gpio_swd_write_fast(), bcm2835gpio_write(), COMMAND_HELPER(), get_gpio_value(), initialize_gpio(), is_gpio_config_valid(), is_gpio_configured(), parport_init(), parport_quit(), restore_gpio(), and set_gpio_value().

init_state

enum adapter_gpio_init_state adapter_gpio_config::init_state

Definition at line 70 of file adapter.h.

Referenced by COMMAND_HELPER(), initialize_gpio(), and parport_init().

pull

enum adapter_gpio_pull adapter_gpio_config::pull

Definition at line 74 of file adapter.h.

Referenced by COMMAND_HELPER(), and initialize_gpio().

---

The documentation for this struct was generated from the following file:

• adapter.h